How Do I Set My Remote Control to Control a Different NVR?
To use the included remote controller, each recorder needs a unique Unit ID number that corresponds with a Remote Control number. By default your recorder and remote controller are both set to ID 1. You can change the ID number of the NVR and Remote controller so that a specific controller only controls a specific NVR.
To assign a unique Unit ID on the recorder:
- Right-click the Live screen and click Menu.
- Click System.
- Select Basic/Advanced Setup Mode and click Advanced.
- Click Remote Control ID.
- Select an ID number (1~10).
To set the number on the Remote Controller:
Press DVR SELECT on the remote controller and enter the corresponding Remote Control ID number at the same time to operate the recorder.
______________________________________________________________________________________
NVR firmware versions prior to v10858 require different instructions to set the Remote Controller ID.
To assign a unique Unit ID on the recorder:
- Right-click on the Live screen and click Menu.
- Click System.
- Select Basic/Advanced Setup Mode and click Advanced.
- Click RS485 Setup.
- Select Unit ID and click Num.
- Use the on-screen keyboard or a USB keyboard to assign an ID to your recorder.
- Click OK.
To set the number on the Remote Controller:
Press DVR SELECT on the remote controller and enter the corresponding Remote Control number to operate the recorder. For example, if the Unit ID is set to 225, press DVR SELECT on the remote controller and then press 2 immediately.
Unit ID | Remote Controller ID |
224 | 01 |
225 | 02 |
226 | 03 |
227 | 04 |
228 | 05 |
229 | 06 |
230 | 07 |
231 | 08 |
232 | 09 |
233 | 10 |
234 | 11 |
235 | 12 |
236 | 13 |
237 | 14 |
238 | 15 |
239 | 16 |